ferroalloy refining ladle

Main Applications:

1. Refining ladle is a ancillary facilitiesin for MC/LC-FeMn pruducing. It is used to recycle manganese from manganese slag and Pre-desilication for hot FeMn

In shaking state, the sicillon contained in liquid non-standard MC-FeMn react with the manganese in manganese slag, recycling about 75% manganese from manganese slag which melt into the liquid non-standard MC-FeMn,also it can reduce the silicon content in FeMn .This will not only maximize recycle manganese from manganese slag, but slao shorten the refining time in refining furnace. With refining ladle you can reduce the requirement for manganese component and purchase low-cost manganese arc, resulting in enormous economic benefits.

It can recycle about 75% manganese contained in the  manganese slag .

2. Refining ladle is also used to decarburization in the producing of siliconchrome(raw materials for LC-ferro chrome produce)

Mix the liquid silicon chrome with slag powder which is made up of LC-ferrochrome slag and fluorite powder,and then start the refining ladle at 50-70r/min rotational speed for about 10-15 minutes. After treatment, the carbon content can be reduced to below 0.02%, decarburization efficiency above 90%.

Advantages:

Low-input, high-quality, simple operation, easy maintenance.The ferroalloy refining in converters features easy sedimentation, less burning loss, and high ratio of recovery .Since its introduction, it has been well received by extensive customers.

Main technical parameters: